SW300-Aotrs 04 Murder Fightercruiser

Aotrs

Please note, to due the Murder's enormous size, it is only considered printable for FDM printers, thus no attempt has been made to hollow it out for resin or SLS printers; it should be considered closer to terrain than a vehicle. It may not even be suitable for all FDm printers. (It barely fits on the Prusa I3Mk3 and I would not have trusted a 24+ hour print on the Replicator myself!) Please check your printer is going to be big enough before purchasing!

Scale: 1:300th (6mm)

Size (Bounding Box): 264.0mm x 138.0mm x 95.36mm; Hull only (for printer size check)): 228.0mm x 125.82mm x 82.76mm

Locking turrets: Primary, secondary. The nose beam turret is further mounted so it can be (completely unnecessarily) swivilled to face any direction.

Supports: Not available at this time, sorry.

Mounting: 3.4mm diameter flight stand hole located at base; flight stand provided (note this is a 20mm stand, shorter than normal due to the Murder's size). The flight stand is entirely optional, however.

Scaling Notes: Yellow. Parts potentially affected by scaling: Flight stand hole, wall thickness, thin parts.

Entirely Optional Lore PDF included.

Photos of FDM print. (Prusa I3 Mk3) Final photo demonstrates the fully mobile nose beam turret.

For FDM Printing: Use files 2hull, 1turrettop, 2beamturretmount, 2beamturret and two of 1turretside.

For Resin/SLS Printing: NOT recommended, even if you can find one big enough, as there is no hollow version.

Note: Fitting the beam turret into the mount requires basically bending the mount and making use of the flexibility of plastic. You may need to use some modelling pliers depending on your material, so I recommend you at least don't complete painting the mount until you have fitted the (painted) beam turret in so that you only have a bit to touch up if it proves truculent.